Four additional 8mm x 1” hex bolts may be required. Step 3. Align the nerf-step brackets with the factory bolt hole locations. NOTE: Be sure the shorter tail bend is towards the front of the vehicle. Start all …

Step 7: Starting with the rear bracket, adjust step as close to the body as possible without making contact and torque both bolts tight. Then repeat same step with the front bracket and the center bracket.

nine 8mm OE threaded stud Step 4: Using the supplied 8mm flanged nuts, fasten all nine mounting positions. Leave loose at this time. (Fig.B) Fig. B ar bracket, push up towards the pi weld so the 3” …

Step Systems C14 & C15 Chevy-GMC Crew & Double Cab Models national Copy Right Law. Protected Patents include US Patent #658 783, #6874801, #7416202. Other patents nd continuances pending. …

Step 2 Remove any factory hardware and discard. (Fig. A) ting with the driver side, position step up to the body of the vehicle and align the brackets up with the factory mounting l

PLEASE READ EACH STEP THOROUGHLY BEFORE INSTALLATION Step 1: Locate the driver's side Nerf Step by matching the shorter tail bend to the front of the vehicle. NOTE: Some models have a …

N-FAB

Step 3: Carefully slide the light bar through the 1”inch slotted hole in the bumper until the four brackets align. Next, start the two 3/8”x 1” hex bolts and 5/16” washers in each bracket and hand tighten.

N-Fab Step Installation: First locate the driver side step. The step that is further away from the end of the tube will go towards the front of the vehicle. Using the supplied M8x25mm Hex bolts, install the step …

TX 77066 Phone (281) 880-6322 - Fax (281) 880- ep Step 3 Starting with the driver side, position step up to the body of the vehicle and align the brackets up with the factory mounting locations. lts into the …